Ford FE Stroker Combinations

Ford's FE engines, from the 332 through the 428, ran from 1958 to 1976 on one 4.63-inch bore spacing, with the 427 and the 428 Cobra Jet at the top of the line. The FE figures below come from the crank and piston makers' catalogs and factory specs, shown only where two references agree.

For a FE bore and stroke not listed, use the displacement calculator; for rod angle and side load, the rod ratio calculator.

Work in progress. We are still filling these tables in from factory manuals and parts makers' catalogs, and a dash means we have not confirmed that figure from two sources yet. Have a figure we are missing, or see one that is wrong? Suggest an edit

Common FE stroker combinations

CombinationBore × strokeCubic inchesRodCompression heightRod ratio
3524.000" × 3.500"351.96.540"1.880"1.87
3904.050" × 3.780"389.66.488"1.792"1.72
4064.130" × 3.780"405.16.488"1.792"1.72
410 Mercury4.050" × 3.980"410.26.488"1.692"1.63
4274.230" × 3.780"425.06.488"1.792"1.72
4284.130" × 3.980"426.56.488"1.692"1.63

Compression height = deck height − half the stroke − rod length.

Crank strokes sold for the FE

StrokeRod lengths sold with it
3.500"6.540
3.780"6.488, 6.490
3.980"6.488, 6.490
4.125"6.700
4.250"6.700, 6.635

Compression height by stroke and rod length (10.170" deck)

Stroke6.488" rod6.540" rod6.635" rod6.700" rod
3.500"—1.880"——
3.780"1.792"———
3.980"1.692"——1.480"
4.125"———1.407"
4.250"——1.410"1.345"

* very short piston: the pin bore runs into the oil ring groove, so few pistons are made this short.

FE blocks: bore and deck height

BlockStock boreDeck heightStock strokeStock rod
330 truck (MD/HD)3.875"—3.500"—
352 (1958-67)4.000"10.170"3.500"6.540"
360 truck (1968-76)4.050"—3.500"—
361 (Edsel 1958, truck)4.050"—3.500"—
390 (1961-76)4.050"10.170"3.780"6.488"
391 truck4.050"—3.790"—
406 (1962-63)4.130"10.170"3.780"6.489"
410 Mercury (1966-67)4.050"10.170"3.980"6.489"
427 (1963-68)4.230"10.170"3.780"6.488"
428 (1966-70)4.130"10.170"3.980"6.488"

Calculators