Ignition Timing Chart

Total timing is what the engine sees at full throttle: the initial timing set at the distributor plus the mechanical (centrifugal) advance. At part throttle, vacuum advance adds more on top. All figures here are crankshaft degrees before top dead center (BTDC); factory specs for the mechanical advance are often printed in distributor degrees, which are half as many.

These are starting points for a carbureted or distributor engine on pump gas. To plot a full advance curve against rpm, use the ignition timing curve calculator.

Timing chart by engine type

EngineInitial (idle)Mechanical advanceTotal at full throttleAll in byVacuum advance (cruise)
Small block Chevy, Ford or Mopar, street8–14°+20–24°34–36°2,500–3,200 rpm+10–15° (45–55° total)
Performance small block (bigger cam)14–20°what brings total to 34–36°34–36°2,500–3,200 rpm+10–15°
Fast-burn chambers or high compression——30–34°——
Big block Chevy, street——34–36° (32–34° for GM's 502s)——
GM LS (fast-burn chamber)——24–28°computer controlledcomputer controlled

Crank degrees BTDC on pump gas at sea level. GM lists 36° total at 4,000 rpm for its 454 HO crate engine and 32–34° for the 502 HO and ZZ502. Cruise timing of 45–55° is normal at light load; it disappears under load when manifold vacuum drops.

A typical street small-block curve

RPMFull throttle (initial + mechanical)Light-load cruise (+ vacuum)
Idle (800)12°22–27°
1,00012°22–27°
1,50018°28–33°
2,00024°34–39°
2,50030°40–45°
3,00036°46–51°
3,000 and up36°vacuum advance drops out under load

An arithmetic example, not a recommendation: 12° initial, 24° mechanical advance starting at 1,000 rpm and all in at 3,000, and 10–15° vacuum advance at light load. Whether vacuum advance acts at idle depends on whether it is on ported or manifold vacuum. The right curve depends on compression, cam, chamber, fuel and gearing.

How to set it

Frequently asked questions

What should initial timing be on a small block Chevy?

About 8–14° BTDC for a street engine with a mild cam, and 14–20° for a bigger cam that idles at low vacuum. What matters more is that total timing at full throttle lands around 34–36°.

Is 10 degrees of ignition timing good?

As initial timing on a stock or mild V8, yes: 10° BTDC is a common factory setting. It only says where the timing starts; check that the total reaches the 34–36° range with the mechanical advance all in.

What is total timing?

Initial timing plus the full mechanical advance, read with the vacuum advance disconnected at an rpm past where the advance stops increasing. It is the timing the engine runs at full throttle.

Why do LS engines need less timing?

LS heads have compact, fast-burn chambers, so the mixture burns faster and peak pressure arrives on time with less advance; 24–28° total is typical. The engine computer sets it, so it is changed with a tune, not a distributor.

Related