Small-Block Chevy Head Gasket Thickness

Compression and quench math needs the gasket's compressed thickness, the height it crushes to once the heads are torqued, not the thickness of a new gasket on the bench. For the small-block Chevy that figure depends on the gasket type and the year, so the chart lists them separately.

Use the figure for your gasket in the compression ratio calculator or the quench and deck height calculator.

SBC head gasket compressed thickness by year

EnginesYearsFactory gasket typeStock compressed thickness (NHRA blueprint)Aftermarket steel shim, compressed
265, 283, 327, 302, 350; 307 to 19731955-1969Steel shim.018".015" (Fel-Pro 1094)
350, 305, 2671970 to mid-1980sSteel shim.016".015" (Fel-Pro 1094)
262 V8, 1976-77 3051975-1977Steel shim, smaller bore.020"—
4001970-1976 (trucks to 1980)Composition with steam holes.034"—
L05 / L31 5.7 trucks (GM service gasket 10105117)1984-1999Composition, stainless fire ring.028" (GM)—

NHRA's blueprint gasket figure is the thinnest gasket allowed in stock classes, which works out to the factory gasket's compressed thickness. The 1987-92 L98, LB9 and L03 are left off: their gasket type isn't confirmed.

Why published SBC gasket figures disagree

Small-block Chevy steel shim gaskets get quoted anywhere from .014" to .026". The figures describe different gaskets measured different ways:

When you have the gasket in hand, use the compressed thickness printed on its package; that's the number the compression ratio calculation wants.

Questions

What is the stock head gasket thickness on a small-block Chevy 350?

The factory steel shim gasket compresses to about .018" on 1955-69 engines and about .016" on 1970 and later 350s. The 400 used a thicker composition gasket, about .034".

Can I put a steel shim gasket on a 400?

Only one made for the 400. Its block and heads have steam holes between the cylinders, and the gasket must have matching holes or the engine can develop hot spots.

How much does a thinner gasket raise compression?

On a 350 with 4.030" bores, each .010" of gasket thickness is roughly 2 cc of combustion volume, worth about two tenths of a point of compression on a typical 9:1 engine. Run the exact numbers in the compression ratio calculator.

Calculators